Rob
April 21st 2003, 08:21
I've just bought a used OMP seat and I was looking to install it this weekend. I decided not to use the sliders that came with the seat, but used the Beetle ones.
I'm pretty sure I can make this work, but I do have to say the original seatframe looks a bit flimsy...
I wonder if it would hold up after a couple of AutoX sessions.
Any ideas ?
I couldalso just weld 2 crossbars from the heaterchannel to the tunnel and mount the seat (wit the original sliders) on there...
What do you think ?
Rob.
I'm pretty sure I can make this work, but I do have to say the original seatframe looks a bit flimsy...
I wonder if it would hold up after a couple of AutoX sessions.
Any ideas ?
I couldalso just weld 2 crossbars from the heaterchannel to the tunnel and mount the seat (wit the original sliders) on there...
What do you think ?
Rob.