914 dash panel, or just a good source in Dallas?

[piledriver]

Hey, Joe, I'm looking to replace the distorted, shrunken vinyl on my 914 dash (the flat part) with a hunk or so of CF.
As it is like a 3"x4 ft flat steel piece in several small sections, I figure I could do it myself and just glue it on to the old steel bits...

This is purely cosmetic...

(Actually, CF knee and dash covers might be quite popular, but I know you're maxed out with the new job and such)

ciao

[Supa Ninja]

I've been wanting to do that to my 14 too.

[Carbon Joe]

I can make you a thin (.030) panel or panels with an adhesive backing, that you can cut and fit yourself. Just let me what sizes and I'll let you know the cost