944 n/a vs 4 pot brakes on an '03

[trevorbrady]

if 944 spindles, disks, hubs calipers etc were fitted to a 1303 could 4 pot calipers be fitted later on as a bolt on?

What I'm really asking is whether the bolt spacing and "offset" of the 4 pots is the same as the single piston ones??

same at the rear... :confused:

thanks

[Hollandbugpower]

i was just thinking about that!!!

i also have the system of 944 bolt on my 03 because the big reds where to expensive for me.

Now i'm saving for some money because i do want the big reds because they are very brutal.

i've searched the internet and this is what i found.

first i begin with the easie part IMO, thats te rear, if you mount 924s with the vented disks, that should be a bolt on your 944

and for the front i think this should be the same, the spindles and hubs look the same of the 924s and 944.

i don't know if it's correct because i didn't measure things, i only saw pictures and know how my system looks

i have the same questions, but a question of mine is, does somebody with big reds or anather S setup have some info about:

the sizes of disks
the width of the disk (from bolting to the other end of the disk
the mounting screw distance of the callipers


thanks and greetz RON (hollandbugpower)

[Hollandbugpower]

by the way look at these two sites

then you can see that IMO the use 944 stuf

http://franklinsvwwerks.com/new-product3.htm

http://www.mbt-engineering.de/


gr ron