901 output flanges (930 CV)

[rioprelude]

I've got a 1969 Porsche 901 5-speed Transmission that apparently has the early output flanges that should work with Type 1 CV joints. I've already purchased the full 930 CV setup and need the 930 flanges for the transmission.

If anyone would like to sell me the 930 flanges or trade for my Type 1 flanges let me know!

Thanks!

[Steve C]

Hi

I doubt that Porsche make a flange to suit that transmission and CV combo. So you could get your existing flanges altered or have an adaptor plate made up to bolt onto your output flanges that would take the 930 CV. The adaptor would be useful if you needed adjust the length of the axles if they were too short.

Steve

[rioprelude]

I was hoping the later model flanges referenced in this thread would do the trick:

http://www.germanlook.com/Forums/showthread.php?t=4236

I'll post the question in the Transmission section to verify.

Thanks for the response!