Looking good Dave!

What are those going for? I hope you don't mind but I may want to copy, it's very clean and simple and does a great job of what it needs to do.

Jason

I think it was $190 shipped from down-unda.

After tossing a couple of ideas around on were to mount my new shift light. I cut a plate to fit between the steering wheel and hub, drilled it up, painted it and mounted the shift light. I had to buy a 3 wire spiral cord and 3 pin connector so I can turn the wheel and allow the cord to stretch. I still need to wire it all in.
http://i209.photobucket.com/albums/b...7.jpg~original
I got most of the engine bay wiring done. Still need to rewire the tag light and run a new pick to the third brake light. I cleaned up all the old wiring and ran everything thru heat shrink tubing, then wrapped it in nylon spywrap were it needed extra protection.
http://i209.photobucket.com/albums/b...8.jpg~original
Still need to wire in the shift light, 2 relays for fuel pump and Mallory 6AL and wire the 6AL. I might need to wire in a Tach adapter if it does not work with the new CDI box.
My list is getting shorter. Only 3/4 of a legal pad page.

Wow, you got some cool touches going on. Hmm 3/4 page on a legal pad huh. I think my list is an entire legal pad :lmao: . Keep going... I still have shotgun right?

you will have to have shotgun cause thats all there is. i dont think he is handin over the keys just yet (even though more have driven my car in the last bit than ever b4)

When I (if I ever) get my car done there will be some people driving it too. :D

very cool! :)

Yes a shotgun ride is still reserved for you.;)

Dave ,
Looking very cool -as always .

Jonathan

Thanks Jonathan. Hows yours running.

I made a change of linkage. Love this set up. Can't wait to drive it.
http://i209.photobucket.com/albums/b...9.jpg~original
http://i209.photobucket.com/albums/b...1.jpg~original
http://i209.photobucket.com/albums/b...0.jpg~original

that looks killer dave i cant wait til i get mine. hopefully i will have it soon.

Nice setup Dave!

After seeing your pic, i just realized i never got back to Pete with measurements for my setup. :banghead:

Look's slick! Nice install!