Nice meaty tyres! And i like the solution you did on the rims of the cookies.
|
Thanks, it wasn't cheap but neither was buying 3 piece rims so that I could get the correct offset.
I did feel a little guilty having genuine Porsche wheels modified, I'm over it now |
Here in the Netherlands a lot of genuine Porsche rims are massacred for the auto cross (widened and narrowed). And after some beating they will end up in the trashcan.....
So don't feel guilty ;) |
1 Attachment(s)
I took my Beetle out to Powerplay on the weekend, fitted up the new M&H for a few heat cycles (skids)
|
2 Attachment(s)
Hi
Finally got a dry Wednesday night so I took my bug out to the drags. Getting used to launching and shifting gears again, I need some improvement. I was getting some wheel hop which I'm sure caused me to break a drive shaft. I need to tie the motor and trans down a bit better Its a custom drive shaft, modified 944 with a 930 CV flange welded on. The guy who made them cant do anything for 5 weeks so I'm trying to organise getting one done so that I can run at the VW Nationals Supersprint. If anybody knows of someone that could help with welding and machining let me know. Best ET was 11.803 and best MPH 124.29 |
Ouch! Sorry you ran into issues!
Jason |
oofffff, done that before on a trans output shaft.
|
1 Attachment(s)
Hi
I had some new billet 944 stub axles made in in EN26. Im fitting some Subaru Group N engine mounts when they turn up from Japan and Ive fitted Superpro urethane bushes to the front engine mount cross member. Hopefully this might help my wheel hop issue |
That are some nice pieces sir!
|
All times are GMT -4. The time now is 17:53. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved