New c/f maker?
I was planning on asking joe to do my c/f work, and he announces he's done. Anyone know of other carbon fiber part makers?
|
It's not so hard to do yourself...it's just time consuming, and although expensive initially, net wise after everything is said and done, you save alot.
It's just that alot of people haven't got the moneys to just drop down for the sake of experimenting and/or learning...or just don't want to.... |
I found a guy out of San Diego but I think I'm getting ripped off by him.
|
aircooledinnovations
I am doing an early lid only at this time but will soon be doing other items. Check out my site @ www.aircooledinnovations.com
Thanks Don Thompson |
Give Creative Car Craft a call. I talked to them a couple months ago and they were considering adding CF parts to their mix...
|
Quote:
|
I've mentioned it to Stu quite a few times, but he says he's too old to start something new. It's too back because they would be great. CF is layed up differently than FG, and he just doesn't seem interested.
Jason |
I have no problems with ordering c/f from one of the many reputable places in the UK. There are some parts I would prefer in kevlar-c/f for appearance purposes, and some for safety purposes. I don't know of anyone anywhere in the world doing that right now. Until then, I am just going to go against the GL grain a bit and keep some parts chrome.
|
All times are GMT -4. The time now is 12:56. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved