1303 floor pan dimension ?
Wasn't sure where to post this question but...
Does anyone have a bare 1303 floor pan, I need a measurement from the rear of the torsion tube to the end of the frame horns. Any help would be much appreciated. |
Nah, no loose floor pan but my engine is out, so then measurement would be easy then too right?
Rear of torsion tube is against the tube vertically? |
don't forget it necks in for the splined section..
|
Thanks fellas, I ve sent you both pm's .
|
i have a bare 1303 pan that i can get measurent for ya.
|
Ah thanks CookVW that would be great. As Ricola has said the torsion tube necks in for the splined section so if you could please give the dimension from the main/large section of the torsion tube that would really be helpful. :cheers:
Graham |
|
Quote:
|
i will get you the needed dimensions in the morning and ill post them up asap.
|
Hi Just measures a spare 75 1303 pan at the side of my garage, its 53cm, thats from a straight edge across the ends of the horns to the torsion bar tube just out from the pivot box
|
Quote:
|
Quote:
Thats what I like about this site/forum, you post a question, it gets a handful of views and within a week people are jumping in and helping out :D. |
All times are GMT -4. The time now is 12:39. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved