1.7 type IV head
Hi everyone, I am getting to a point where I can get the second spark plug hole installed. I un-did some of my last porting, due to having seen someone else porting which I felt was much better. These heads are from a 411, they were from the 1.7 engine. I think the exhaust is 39mm X 41 or 40mm. Have a look and make suggestion on any imporvements I can make before the plug addtion and coating and "O" grooves.
http://i86.photobucket.com/albums/k9...9.jpg~original http://i86.photobucket.com/albums/k9...d.jpg~original http://i86.photobucket.com/albums/k9...7.jpg~original http://i86.photobucket.com/albums/k9...5.jpg~original http://i86.photobucket.com/albums/k9...d.jpg~original This is the flange, the exhuast pipe will be welded to it http://i86.photobucket.com/albums/k9...7.jpg~original I will need to have the seats re-ground. Hi, am havig my machinst mill me a "O" ring groove into the head and cylinders, man I need to get this engine running. http://i86.photobucket.com/albums/k9...8.jpg~original |
Dual spark plugs
Hi everyone, I had European Motorworks add a second spark plug to my 1.7 and 2.0 heads.
http://i86.photobucket.com/albums/k9...1.jpg~original http://i86.photobucket.com/albums/k9...6.jpg~original http://i86.photobucket.com/albums/k9...4.jpg~original http://i86.photobucket.com/albums/k9...2.jpg~original Here are the 2.0 heads. http://i86.photobucket.com/albums/k9...9.jpg~original http://i86.photobucket.com/albums/k9...6.jpg~original http://i86.photobucket.com/albums/k9...0.jpg~original Jorge at EMW said that the second spark plug should be angled toward the exhaust valve, also there are 10mm. I will have the heads cryoed and re-coated. |
All times are GMT -4. The time now is 21:51. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved