sources for type iv camshafts
Hi everyone,
Just wondering who you recommend for aftermarket type iv camshafts? I was looking at FAT's website, but they don't have an email address - which is a bit of a pain. FYI - camshaft will be for a 2.0 turbo type 4 engine, I'm keen to hear any suggestions on cam specs. Cheers, Cam |
Quote:
But Pauter and Web Cam are on the top for can builders. |
Thanks efvee. I'll look into them.
Cheers |
I would recommend Pauter also. Their grinds work very well.
For 2 ltr turbo, just pick a moderate duration (between 250-260 at 0.05") and proper lift (0.5" at the valve) and you'll be fine :-) |
Thanks Wally! :-)
Do you run the Pauter lifters too? |
Didn't even know Pauter sold lifters tbh.
As for lifters, I Always use type 1 lifters, ideally TP light weight tool steels. |
Quote:
|
All times are GMT -4. The time now is 09:54. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved