6 stud pattern of a type IV engine
Hi, I have a total of 3 sets of type IV heads. My problem is I didn't know of the 6 stud applications until it was too late to have it done. Does anyone have pictures of the 6 stud type 4 engine? EMW only does 5 stud.
|
Havenīt seen it done on a type 4 before. Just make sure the stud spacing is equal.Take a look at what Pauter does. I would also make sure there is enough room in the head for the nuts. I honetly donīt believe that a 6 stud is necessary unless you plan on running huge amounts of boost.
|
Quote:
Thanks |
All times are GMT -4. The time now is 22:48. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Đ www.GermanLook.net 2002-2017. All Rights Reserved