Master cylinder sizes
I am putting an OBP pedal setup in my car and wanted some recommendations on master sizes for front rear and Trans hydraulic actuation. I should know the answers but 10 years of building this thing has blurred many lines...
Thanks guys! |
Oops using Boxster S calipers front and rear. Have not purchased Trans slave yet.
|
I know Tilton has a worksheet for their products. OBP may have one for theirs.
|
I'm using 0.625s for my 996 brakes which is the smallest available and I would go smaller if I could... I have 0.75 for the clutch but that is dependant on what size slave, clutch etc you are running...
|
All times are GMT -4. The time now is 11:22. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved