GermanLook Forums

GermanLook Forums (https://www.germanlook.net/forums/index.php)
-   Body (https://www.germanlook.net/forums/forumdisplay.php?f=42)
-   -   1303 floor pan dimension ? (https://www.germanlook.net/forums/showthread.php?t=11853)

graham January 21st 2016 12:23

1303 floor pan dimension ?
 
Wasn't sure where to post this question but...

Does anyone have a bare 1303 floor pan, I need a measurement from the rear of the torsion tube to the end of the frame horns.

Any help would be much appreciated.

Wally January 21st 2016 15:26

Nah, no loose floor pan but my engine is out, so then measurement would be easy then too right?
Rear of torsion tube is against the tube vertically?

ricola January 21st 2016 16:11

don't forget it necks in for the splined section..

graham January 22nd 2016 01:26

Thanks fellas, I ve sent you both pm's .

cookvw January 22nd 2016 01:33

i have a bare 1303 pan that i can get measurent for ya.

graham January 22nd 2016 04:36

Ah thanks CookVW that would be great. As Ricola has said the torsion tube necks in for the splined section so if you could please give the dimension from the main/large section of the torsion tube that would really be helpful. :cheers:

Graham

spannermanager January 22nd 2016 16:37

Any good.

http://www.eagleownersclub.org.uk/Te...dimensions.jpg

graham January 22nd 2016 17:36

Quote:

Originally Posted by spannermanager (Post 90069)

Cheers Spanners not sure if I can get it off this drawing though as its not to scale. Ideally i need the dimension from the back of the torsion tube to end of the frame horns. The drawing here only shows it to the inside of the pan and the body is on my car. If any one is wondering why I don't just measure mine its because the frame horns have already been removed :eek:

cookvw January 25th 2016 23:47

i will get you the needed dimensions in the morning and ill post them up asap.

Steve C January 26th 2016 01:10

Hi Just measures a spare 75 1303 pan at the side of my garage, its 53cm, thats from a straight edge across the ends of the horns to the torsion bar tube just out from the pivot box

graham January 26th 2016 17:50

Quote:

Originally Posted by Steve C (Post 90085)
Hi Just measures a spare 75 1303 pan at the side of my garage, its 53cm, thats from a straight edge across the ends of the horns to the torsion bar tube just out from the pivot box

Thanks for taking the time to do that Steve :cheers:

graham January 26th 2016 17:57

Quote:

Originally Posted by cookvw (Post 90084)
i will get you the needed dimensions in the morning and ill post them up asap.

Thanks for your response cookvw but I've sorted it, as you can see Steve C has had his measuring stick out :D

Thats what I like about this site/forum, you post a question, it gets a handful of views and within a week people are jumping in and helping out :D.


All times are GMT -4. The time now is 18:10.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved