Feedback on my engine setup
Hi masters of the Type IV,
I would like your feedback/comments to finish my engine build. The idea is to have power & torque :lmao: > 2366cm3 (71x103mm) > Max rev 7000-7250 rpm > mainly street use but would like to go also on the track > CR 9.5:1 or maw 10:1 I will be pleased if you can advise me on the valve train & flywheel selection. Already procured Case : Type IV 2.0 Porsche 914 Crankcase : DMS 71mm 2.0 CW + Heat treatment Rods : H-Beam CrMo 4340 - std 2.0 length 24mm pin Cylinders : QSC 103mm Nikasil internal treatment Pistons : JE 103mm custom made for nikasil cylinders (flat top design) Heads : Bus CJ 2.0 prepared by B.A.S. Germany (44x38/Complete valve seat job/Ported intake) Heads chambers need to be reworked Lifters: 56gr HD T1 lifers + bushings Carburettors : 2 x 45 DRLA on short & aligned manifolds Oil pump : Melling HD Cooling: Porsche 911 260mm Fan (11 blades) To buy - Valve retainers: Jake Rabbit Ti retainers - Spring: Berg dual springs - Pushrod: Gene Berg 160000 PSI HD pushrods - Berg HD lash caps + valve collets - Ignition : Mallory (Unitlite + CDI Hyfire VIA + coil) Valve train options German option - Rockers arms: Porsche 914 1.7 (8mm) + 911 adjusters + solid spacers - Camshaft: Schleicher 324° (106) US option - Rockers arms: Pauter 1.48 rockers set - Camshaft: Pauter camshaft: ? Flywheel option I've got the original forged 215mm 914 flywheel nevertheless it will not fit a std beetle gearbox. Does it exist a diameter of T4 flywheel that willl fit both T1 beetle gearboxes AND Porsche 901/915 gearboxes ? In any case flywheel will be lightened and balanced Cheers, Obi |
Hi, Hi spec indeed for a streeter, but good luck with it.
It just so happens that i'm having a run on 228mm flywheel and clutch adaptions into T1 bell housings, these go in with careful clearancing, i don't know why the 215mm should not go in also, unless there's something unique about the 914 fly' that I'm not privy to? |
Hi
I've had both 215 & 228 mm flywheels in bug bell housing, they do fit with some patient grinding, this was on WBX motor. Steve |
Thanks guys,
It exists at least 2 kind of 215mm flywheels, the Porsche 914 one, the only one forged in the vw air-cooled range of engine. It is higher than the other 215mm T4 flywheel. That's why it is more difficult to fit it in a std beetle gearbox. |
All times are GMT -4. The time now is 00:44. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved