Linkage for Upright kit and Webers
 

I was curious if there was a special type of linkage I need to use with the Sharpbuilt upright kit for my type4 engine, I have weber40's and no linkage yet, any suggestions? or can I just use like some scat hex linkage and be done? Thanks

On this page, http://www.germanlook.com/Forums/sho...threadid=1286, there is a brief discussion over the matter. If you want to skip that, its says a bell crank linkage is best for a few reasons one being that the hex bar linkage has to be modified to fit.:)

hey thanks allot tito, i thought i thought i scanned all the posts making sure there wasnt already a discussion on this, but i must have missed it, thanks allot for your help.