|
Fiberglass frontend/missalined? how??
Hey guys
Well here we go again... I got all my NEW frontend parts on- ( 2" Narrowbeam/Tie rods,Stablizer,Shocks,Streering box,Trailing Arms) But now my Fiberglass front is off set.. it fits fine on the drivers side (right on the lip/under Windsheld) 1.25" off the tire Passanger side: is 2" off the tire & like 3" or so tweeked out by the running board.. anyone mess with this stuff before? Thanks Troy |
Did you pre-fit it before? If the FG frontend sat for a while, especially if it was in the sun or on a un-level surface, it's possible that it warped some. :(
|
Damb
it was sitting for a few weeks.. socal had a bit of rain hot/cold changes... :( guess its time for $$$ NewOne $$$...eh.. the pains going tobe hard to match.. http://memimage.cardomain.net/member...8_136_full.jpg This CreativeCarCraft is About $980 I was thinking a set of Bearclawl's to hold it down .. http://www.creativecarcraft.com/debopfe.jpg |
bearclaw latches right?! they would do a damn good job at holding the front end down....you could use them instead of dzus fasteners or what ever else your using...you would just have to think a way of mounting the release...
good luck! |
| All times are GMT -4. The time now is 14:53. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved