GermanLook Forums - Setting The Timming(1835cc CompUfire(DIS-IX)

GermanLook Forums (https://www.germanlook.net/forums/index.php)

- Engines (https://www.germanlook.net/forums/forumdisplay.php?f=11)

- - Setting The Timming(1835cc CompUfire(DIS-IX) (https://www.germanlook.net/forums/showthread.php?t=5752)

Troy_Audio

March 28th 2005 16:47

Setting The Timming(1835cc CompUfire(DIS-IX)

Hey , GLookerz

This Is my first time doing this so I just want to make sure im fallowing
all the steps..
I have a sears Timing light..
I need to hook
Ground( Neg) to - (Bolt/Body Ground)
Power (B+) to Alt Power 12v
Clip(Light indacaor) to - Stark Plug #1

Now how do i Advance The spark?
by turning the distributar?
here is a Link Also video of it running & A pik of my motor
Thanks Troy
>>My Project<<
>>1835cc The Video<<
http://memimage.cardomain.net/member...8_452_full.jpg

Shadowbug

March 29th 2005 19:43

had this same ignition on my engine, but pulled it in favor of a prorammable electronic unit.

it is adjusted the same as you would for a regular 009. which means turning the distributor unill its set where you want.

the only advantage this ahs over the 009, is that you get a hotter spark. timing is the same.

Troy_Audio

March 30th 2005 14:21

Iv got it running at 0-Degz
Its ok but i got a pop comming from the right side air filter?
I can see a small flash too..
I think im running a lil lean but i have'nt got to that part yet..
Any quik thouts on this?? :rolleyes:

All times are GMT -4. The time now is 16:55.