need some wheel opinions
 

I've been trying to run wider wheels on my bug. Right now, without getting into too many details I've got a choice to make and was hoping for some insight.

I hope to run a 17x7 rim, and the deciding factor is the offset. +35mm or +42mm.

With the +35mm I don't lose as much turning radius ~11%
With the +42mm I lose ~16%

But with the +35mm offset the scrub and bearing wear would be larger. I havn't been able to find the original scrub radius, it would increase in the order of ~52.1% and the edge of the wheel would be ~60mm further out (compared to stock) thus that outer bearing would wear faster.

With the +42mm offset the scrub and bearing wear are not as bad. Scrub radius is now about ~34.6% and the edge of the wheel would be ~52mm further out (compared to stock).

the edge won't be too much further out, when you compare the two, but the scrub and turning radius differs a bit.

thanks for any opinions
Rip