Forum: Engines
May 14th 2003, 22:49
|
Replies: 5
Views: 2,239
|
Forum: Engines
April 18th 2003, 23:55
|
Replies: 44
Views: 14,190
|
Forum: Engines
April 18th 2003, 23:53
|
Replies: 44
Views: 14,190
Cosmetics is not the only reason for the 911...
Cosmetics is not the only reason for the 911 set-up. I am placing a T4 2L with the Fat upright conversion in my 67 bus. When I got the bus th3 T4 was aleady in there, but the Prev. owner had to...
|
Forum: Engines
April 18th 2003, 17:46
|
Replies: 4
Views: 2,845
I already have it converted to the upright...
I already have it converted to the upright conversion, so I don't have to cut anything. Its just the exhaust sticks out too far for the bumper to go on. I figure that I may have to fabricate the...
|
Forum: Transmissions
April 11th 2003, 22:28
|
Replies: 0
Views: 2,263
68 Type 3 tranny for Type 4 2.0L
I am about to put a 68 swing axle type 3 tranny in my bus for my type 4 2.0L. Am I making a big mistake with not going with a prostreet tranny or will this tranny be just fine for a long time?
|
Forum: Engines
April 7th 2003, 01:27
|
Replies: 194
Views: 34,120
Exhaust
Does anyone know if the BAS bus exhaust will fit in a Splitwindow bus with the rear bumper on? If not then what about the FAT exaust?
|
Forum: Engines
April 7th 2003, 01:24
|
Replies: 4
Views: 2,845
Exhaust
I have seen that BAS have a muffler for a bus 2.0L but I am not sure if the clearance for a later model bus is alot different from an early model. They seem to not have an e-mail address so I can't...
|
Forum: Engines
April 5th 2003, 19:15
|
Replies: 4
Views: 2,845
Type IV 67 Camper
Hey I am puttin a T4 2L in a 67 camper with a set of Kadrons. What I was wondering about was whether I would half to get my carbs modified for this motor and where could I find an exaust system that...
|