Forum: Engines
April 22nd 2003, 14:09
|
Replies: 0
Views: 1,841
94 to96mm and fuel injection
I am in the process of planning my 78 bus engine rebuild. I would like to put some 96mm P+Cs in and am wondering what the effect would have on the stock Fuel Injection. will it work? will I have to...
|
Forum: Engines
January 22nd 2003, 17:27
|
Replies: 4
Views: 2,337
This is going back into my bus and will remain...
This is going back into my bus and will remain with the stock type 4 cooling that it came with. my goal with this engine is not necessarily create a hi-po engine but one with ultra reliability that...
|
Forum: Engines
January 22nd 2003, 01:17
|
Replies: 4
Views: 2,337
full flow case
So I have my type 4 all apart and am going to smooth out the inside of the case and remove all the burrs and sharp edges and index my oil pump (30mm type 1) and am wondering what else I should do to...
|
Forum: Engines
December 12th 2002, 14:21
|
Replies: 2
Views: 2,795
what am I doing wrong
I am trying to put my cylinders into the pistons and there is a little chamfer at the top of the cylinder that keeps catching the bottom oil ring spacer and no matter how tightly i fit the ring...
|
Forum: Engines
December 11th 2002, 20:17
|
Replies: 0
Views: 2,086
1700 to 2.0
what are the differences in the 1700 914 case, cam, and crank. My 2.0 L fuel injected engine just froze (I think it is my main bearings, they are OLD) and I MUST drive to my folks house next week. ...
|
Forum: Transmissions
November 26th 2002, 13:11
|
Replies: 6
Views: 3,204
|
Forum: Engines
November 26th 2002, 03:18
|
Replies: 8
Views: 2,404
|