GermanLook Forums  

Go Back   GermanLook Forums > Search Forums

Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: PIOMAC
Forum: Engines May 14th 2003, 22:49
Replies: 5
Views: 536
Posted By PIOMAC
lets see some pictures!

lets see some pictures!
Forum: Engines April 18th 2003, 23:55
Replies: 44
Views: 3,898
Posted By PIOMAC
I forgot to mention that with the previous setup,...

I forgot to mention that with the previous setup, that the engine decklid did close but NOT properly. Now it will close properly with the upright conversion.
Forum: Engines April 18th 2003, 23:53
Replies: 44
Views: 3,898
Posted By PIOMAC
Cosmetics is not the only reason for the 911...

Cosmetics is not the only reason for the 911 set-up. I am placing a T4 2L with the Fat upright conversion in my 67 bus. When I got the bus th3 T4 was aleady in there, but the Prev. owner had to...
Forum: Engines April 18th 2003, 17:46
Replies: 4
Views: 687
Posted By PIOMAC
I already have it converted to the upright...

I already have it converted to the upright conversion, so I don't have to cut anything. Its just the exhaust sticks out too far for the bumper to go on. I figure that I may have to fabricate the...
Forum: Transmissions April 11th 2003, 22:28
Replies: 0
Views: 552
Posted By PIOMAC
68 Type 3 tranny for Type 4 2.0L

I am about to put a 68 swing axle type 3 tranny in my bus for my type 4 2.0L. Am I making a big mistake with not going with a prostreet tranny or will this tranny be just fine for a long time?
Forum: Engines April 7th 2003, 01:27
Replies: 194
Views: 15,702
Posted By PIOMAC
Exhaust

Does anyone know if the BAS bus exhaust will fit in a Splitwindow bus with the rear bumper on? If not then what about the FAT exaust?
Forum: Engines April 7th 2003, 01:24
Replies: 4
Views: 687
Posted By PIOMAC
Exhaust

I have seen that BAS have a muffler for a bus 2.0L but I am not sure if the clearance for a later model bus is alot different from an early model. They seem to not have an e-mail address so I can't...
Forum: Engines April 5th 2003, 19:15
Replies: 4
Views: 687
Posted By PIOMAC
Type IV 67 Camper

Hey I am puttin a T4 2L in a 67 camper with a set of Kadrons. What I was wondering about was whether I would half to get my carbs modified for this motor and where could I find an exaust system that...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -4. The time now is 19:01.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved