|
Thanks for the long reply: the more info the better for most of us!
But you must then like BAS his really stainless steal equal length header with 39mm inner diameter and all mandrel bent! Not a weld in there: you surely must appriciate that ? After all, 1,5" is about 38mm... After that the BAS is about 2" for damper circuit.
BTW I like the pictures of the type 4 headers very much of the site you gave us, bit I'am not too keen on the damper set-up I saw in the type 3 square: it was sticking out a lot!
Thanks,
Walter
|