|
header still isn't on. spent probably an hour each of the past to night to the two little m(*$% f(*#% studs. and they are still not in. don't have the foggiest idea what BAS was thinking in making the tolerances that tight.
carbs are on and firewall clearanced, but can't figure out where to mount the acc. cable housing and kind find the linkage to tie it to the bellcrank linkage. that is holding up the shroud, fan, wiring, coil, CDI and decklid. which is all holding me up from dropping the back so i can get the front in the air, change shocks and drop the suspension which is holding up the front fender beading and the headlight wiring and install. which is holding up the final fender alignment so i can fit the c/f running boards. then there is the scrapers which i just can't seem to get the last little corner right which is holding up...nevermind.
get the picture. i am frustrated.
btw, great idea on the sticker location. will have that in mind. i like it.
|