[Panelfantastic]

Just trying to mimic stock geometry. When I look under a stock IRS, the inner pivot point is in direct line with the springplate/torsion bar pivot point even though they turn on different axis(s). Since I've ditched the torsion setup all together plus turned the inner mount up several inches to correct camber at my lowered ride height, I'm trying to pay close attention to making sure the pivot points still line up so that I won't have suspension bind. I've tweaked this thing around completely away from stock with nothing to go on but a guess, I've never seen it done, could be completely ska-rood... oh, and did I mention I suck at geometry?
Not sure what you mean by offset? I have changed the stock inner mounting point but am also setting the outer point to match it... so they would both be "offset" from stock.