|
so if i'm picturing this right your going to slide a pipe or similar into the trailing arm pivot hole/bushing then mount your spring plate/hiem joint on the arm and adjust the heim so it sits in the center of the pipe. then mount the trailing arm and see where the heim likes to be? i know you don't want to hear it but it would have been sooo much easier had the conversion been done right the first time. oh well. the only suggestion i have is when you are test fitting i would go with urethane bushings. if they start to squeak put rubber ones in but the urethane's will flex alot less when your trying to test fit and line everything up. i wish you luck and keep us posted. cheers!
|