[vujade]

in the front, you will have to run narrow struts (80mm) and most likely a no spacer in the front. I was running a similar setup on my 1302 minus the 944na brakes. You will be right under the front arch within half inch or so.

in the rears, I dont think you will need any spacers because of the offset of that wheel. I have a 7" et55 wheel in the back and had to run a 10mm spacer. You are using a 8" wheel with et30 wheel. You will have 10mm less backspace then I did, so the spacer should be required, especially if you are running the 944 brakes in the rear also. The outside edge of the rear wheel if going to stick out an extra 48mm more then a stock beetle will need to get wider fenders accordingly.