Quote:
|
Originally Posted by Rob
Do you guys think you could also make it from square tubing ?
I've been thinking about the same thing, but without the adjustability.
So basicaly just bracing the 5 points that a Kafer cup brace is using.
Rob.
|
this just what i did but out of round tube and welded mine in.welded the main cross brace to the shock horns and then the rear faceing bars to the main tube then to the gear box cradle,but did not weld them to the cradle but made up some mounts so i can get the cradle out if i want.would not go this route with a swing axle car as you won't get the gear box out agian!
cheers rob