|
I have stock length beam, CB lowered spindles, ghia disk brakes, 6x16 ET36 Fuchs, and 2" wider pre67 CCC fenders. Without spacer, the outside edge of the tire is 1.75" from the top, outside edge of the fender. The verticle clearance from the top of the tire to the inside of the arch with 205/55 R16 tires mounted is about 1" with the beam set to middle (no lowering, no raising). I'm going with a 1.5" spacer. Hope it works...
Based on this, I think the tire would rub the stock fender arch when the front suspension is loaded or the front end is further lowered.
|