|
Broken motor
Well I'm back online after morning the loss of my motor. It seized about a month ago while doing a full throttle, clutch drop burnout. I tore down the engine and sent the short block to Jake for failure analysis and repair. Jake found that the T4 flywheel snout broke and welded to the crank. This caused the front main bearing to seize on the crank. So, a new crank, bearings and flywheel and it's all good. Jake is going to set me up with one of his new lightened billet aluminum flywheels. I'm going to get a rev. limiter to protect the engine from my foot.
On the bright side, I got the experience of tearing down a RAT T4 motor. Ceramic lifters were perfect.
I've made some progress on the car -- wheel spacers, gauge wiring, bumper turn signals, sound dampening, and wing window assy. After getting the engine back together the plan is to get the headliner installed by a shop and finish up final assembly.
Keepin' on,
Bill
|