|
Its not all in yet, but I found that with a 20deg. roll of the rack, I could get a decent angle to the output shaft. I've cut down the stock steering shaft now, and pressed in the Teflon bushing and all is good. STILL waiting for the Flaming River U joint, they must be slow on the draw right now. Bob wanted to machine down the rack to allow it to be rotated at any angle, but then I'd have to have a clamp machined and then it would also be a solid mount, more noise. I have PU bushings for the rack now, and I may switch to rubber in the future if the road feel is too much.
The design is finished, so just waiting on parts before fabrication begins!
Jason
|