|
If you are going to be at a shop with a strut comp. tool you will be able to do it with that. When I first put mine on the shop I went to put the strut together in the middle setting. I needed to put it at the highest setting, rather than take the struts back out and go back to the shop again to change the setting, I made the tool so I could make changes to them without removing the struts. If I were you I would have the shop set them(MaxxStuts) at the highest setting. This will give you a 2 1/2 inch drop and then drive it and see how much it settles. If yours was like mine it will be just right at the top notch.
__________________
NO_H2O
72 1302 Smack Black GL
73 Bus (2L CIS Powered)
66 Beetle, 73 Standard Beetle
72 Pinzgauer 710M
Volksport Kafer Gruppe
|