So my first update:
This are honestly just pics of about two weeks ago (when I had some time). I've been busy (so I said in above answer) with putting in two fuellines of 12mm (where originally sits 1 of 6mm) in. It was verry verry ****ty work, but hell yeah someone got to do it.
At first an pic on which the holes on the backside are good to see. Also are the tules en the cut out piece verry good to see to get the lines in.
An detailpic.
http://www.keversite.nl/fotoalbum/fo...2005232611.jpg
To really get fuel from the front to the back they have to have an exit on the front.
http://www.keversite.nl/fotoalbum/fo...2005232701.jpg
After thtat both sides where welded close.
-Backside
http://www.keversite.nl/fotoalbum/fo...2005232741.jpg
-Frontside
http://www.keversite.nl/fotoalbum/fo...2005232836.jpg
After a lot of "playing" with the Dremel I get this ending result.
-Backside
-Front
I think it looks verry nice, just like off fabrique
Wiebrand