[SpikeSchumacher]

Hey Everyone,

Recently installed a set of 17 x 7" wheels on my '72 Super (1302). The offset was such that I didn't need to run spacers or widen the fenders, the only problem is that I am running a BAS Ahnendorp dual can muffler exhaust, the mufflers sit right next to the valve covers, I have slightly dimpled the mufflers to clearance my new wheels but am still getting a bit of scraping on one side.

I have seen a few exhaust systems posted here that seem to be a large muffler that fits behind the rear apron & exits through the stock exhaust cut-outs. Anyone know where I could obtain these from?

I am running a type 1 based 1914cc with CB Performance 044 heads.

Any info would be greatly appreciated.

Thanks,

Mathias
Monterey, California