|
Well the "t" piece is the part that i was not very satisfied with. Its more like a "Y" now. It should have been made from 2 90degree parts but all i had left was one 90 and one 45 degree bend. so i welded the 45 in the middle of the 90 degree part and hope for the best.
Since i`m one dimension up from the original 2" i have a total of 5" flow area where the thing split.
I dont think this will slow down the exhaust gas. and the mufflers is "see trough" (very loud)
__________________
Check out my project pic`s!
http://www.v-dubs.no/haraune
|