Quote:
|
Originally Posted by Tedzbug
Amazing car..... I was wondering what size heim joints you are using on the steering rack. Is that setup stock bolt in? or is the rack reworked or non-stock?
ted
|
Hi there, the rod ends are crome molly 1/2" and ive made the steering arms out of molly too. The rack is a v-early Mk 1 passat to which i had to have the spline rewoked. I also had to make the rack mounts. The steering shaft has been modified also. To locate the rack properly, i had cut the inner guard away a little and insered weld nuts so all looks factory and was very secure. The other two areas which needed attn is where the steering universal runs under the tank. I had to cut and fabricate a pannel here to clear the shaft. The second area is the pan... the top of the pad head needed cutting away to clear the rack. You can see on the 75 model the differance here. once again was carried out as factory. I have drilled out the steering arms on the stub axles to run a 1/2 " cap screw, also you can see i have run the rod end under the arm with a molly spacer to get the bump steer right. The inner rod ends on the rack are also 1/2" and made special molly spacers here to. To tell you the truth it was alot of work but i do think it's worth it in the end, especialy on a race car. Brent.