Quote:
|
Originally Posted by NO_H2O
I had much the same problem on Ryan's car on the drivers side. A shrinking dolly on the inside and smoth hammer on the outside was what I used to get it close. then a skim coat of mud and 3 coats of Slik-Sand high-build got-er-done.
|
Yeah, that's what I've did this afternoon after some D&C on Sue's Bug. Took it for a drive to get some sandpaper, just to inspire me.
Found out the flat side of the dolly will shrink it, and the rounder side will stretch it a bit.
I think I'll be saving the Slik-Sand for last. I'll etch prime it first (after the hammer work), then mud it, then 2K prime it, then block it, then prime it, then block it,
then prime it, then block it, then... 
One day, I might make a car out of this heap.