Quote:
|
Originally Posted by trevorbrady
the rear suspension of the type3 is the same as a similar year bug. The front axle can be lowered by adjusting the splines, in a similar fashion to the rear of a bug. Apparently it's very easy but I've never done it, maybe someone with a type3 can advise...
|
Correct, first mark where it is, then just loosen the set screw/nut and pull the lower trailing arm in the front out/off the torsion bar and turn them a spline or three (up) and shove them back on, snug up the set screw/nut. Been a while since I've done one, but that should get you going on dropping a t3. Very easy to do.