I Have available a 2270 Type Four Engine Built by Jake Raby this engine comes with fully programmable EFI with DTM Cooling amongst other goodies it is not far off of one of Jakes Superhero engines as far as its spec goes. it is unused and ready to rock,if you are aware of Jakes work an reputation you will know you are dealing with the best money can buy and you may also be aware he has a long waiting list, however this Engine is available now and is currently FOR SALE ON EBAY NOW . Full spec Engine Specs : 2270 TYPE FOUR with programmable Fuel injecteion built by Americas premiere engine builder Jake Raby, see
www.Rabys aircooled Technology or check fourth dimension radio Engine case - 021 / 022 Type 4 Engine Bearings - Original VW KOLBENSCHMIDT Crankshaft - 78.4mm OEM, Balanced counterweighted Connecting rods - H beam 5.400 length Camshaft - web cam, custom grind Lifters - LN engineering ceramic Cylinder and piston assemblies - 96mm cast iron cylinders with 96mm Hypereuctectic pistons Cylinder heads - New castings, full stage II port and polish with hand shaped chambers with balanced chamber volumes Pushrods - Manton Chromoly, cut to length Rocker arms - VW forged units, 1.3:1 ratio, solid spacers Valves - stainless steel made by Marnel Valve adjusters - 911 swivel feet Oil pump - Modified type1 / schadek 30mm gears, blueprinted Ignition - Mallory Unilite distributor Ignition - Bosch Cooling System - DTM Stage IV Flywheel - 210mm RAT conversion Pressure plate - Sachs Clutch disc - Sachs Exhaust - supplied by RAT Induction - RAT EFI with dual TWM throttle bodies and fuel rails. Kit comes complete with fuel pump, pressure regulator and injectors, baseline tuned Inclusing: - Dyno tuning - Cryogenic enhancement - Standard blueprinting service - severe duty valve train - extensive dyno testing - composite lifters Inclusive extras : - Cryogenic treatment upgrade (full engine treatment) - Upgrade to programmable EFI (full kit with dyno set up and tuning included) - Full flow oiling system upgrade The cost of this engine would cost youmore than £ 12,500 at todays prices and you would have to wait aproxamatley 18 months for Jake to start the build due to his long waiting list and demand for his work. the engine is obviously not for the faint hearted neither in pocket nor perfomance it has dyno charts available and has never been used and its waiting at Jakes Engine biulding facility. shipping can be organized worldwide as the engine is currently in Georgia US, Serious enquiries only please, thanks