[njv]

hello.
fitted 35 venturies today while the carbs where in bits i checked the float levels yess i broke my own golden rule the floats acording to the cb dell superformance book where way out!!!

so of course ive adjusted as per at 5mm with the carb top turned upside down and 13 mm with the floats dangling in the wind(and a very cold wind here in germany today too).

before my adjustment it was set more like 2mm-20mm.

well at about 60 kph it falls flat on its nose just sort of runs out of fuel not good im not happy. and i ran out of daylight to8-( .

tommoro i will strip dem both again and put the floats back where they were !

at least this way i will know how i stand with my new 35mm venturies .

thing is it seemed better to drive today not so neck jerking on accelaration it was actually a bit difficult to controll at low speed with the 30mm venturies fitted these where obviously to small for my engine anyway.

im putting another post on with reference to dell float settings see what sort of replys i get .

report what happens tommoro.