[Bug@5speed(US)]

Send me your email..

I will pm you the instructions in our Guide in english..

I have it in a word doc.

But regarding the questions.. you essentially remove the old shifter cut a square where the old shifter use to be. You then fasten with 4 bolts to the tunnel. You can drill the 4 holes then thread them..

If I understand you second question correctly.. The bushing sits below the plane of the tunnel. When you put the shifter back, you push the shift rod thru the hole in the front, then thru the bushing which is supported by the lower bracket of the shifter.

Does that help?
Alex