First videos!
http://www.youtube.com/watch?v=UMgz4PE00xs
http://www.youtube.com/watch?v=40JZL9VJ45Q
Cam break in is done just need to get the axles back in, throttle cable in and clutch cable in to drive her. Still chasing leaks
both valve cover gaskets wont stop leaking and a small drip (now) coming from underneath. I'm worried it's the cam plug or rear main. It was gushing oil before after some fuel got in it, so I changed the oil and the leak lessened by a good margin but it still there. Other than the oil leak and systems are doing well. All the gauges work and and wiring is looking nicer.
2 suprizes though: First the turbo doesn't quiet down the motor as much as I thought it would and noise may be an issue as some tracks. Second, I can't hear the CB straight cut cam gears at all, not even a little bit (exhaust is probably too loud.
Pictures!
Here's the wheel speed sensor, from a 928 not 968 (my bad).
And nicer wiring shots and fire extinguisher mount
