February 23rd 2010, 15:30
|
|
Registered User
|
|
Join Date: Jan 2003
Location: Boulder Creek, CA
Posts: 758
|
|
The sleeves and springs I got from summit racing. I think all the part numbers are on the ultimate suspension thread.
Speaking of the big motor, I sent the spare case off for machining to bring the deck faces down. When I pre-assembled the motor to get deck height measurements I found the 3-4 side to be .020" taller so that will be evened out as well. Initial measurements add up to a .044" deck which will give me a 9.1:1 CR assuming a 59cc chamber. I'm going to measure those next to verify.
A couple of notes:
1. New-ish rings are sharp as @#$&! and I sliced my fingers open pretty good
2. Using a wire wheel to clean the piston tops makes the garage smell like burnt toast
|