Quote:
Originally Posted by paul_f
I'd like to cut and move slightly backwards the pipe that runs near the pulley as it is very close, but I think it will be quite difficult to do nicely without remaking that section.
|
Problem with that part is that it is the 180 degree section that curves right behind the rear apron. If you move it further away from the pulley, it gets close to the apron... You may get away with that, but I have less room as you know
Quote:
Thanks for the measurement, though I wanted the one at the other end of the collector. I think it is 54mm OD but I am not certain.
Cheers
Paul
|
Sorry...but you're correct. That part is OD 54mm.