[EvilOval]

I figured that I would have to fabricate an adapter for the front caliper to mount. All the parts I have are from an 84 so....my thought was to go ahead with the the changeover and use the single pot calipers for the time being until I was ready to change them over to the 4 pot. The main questions are:

-Has anyone made a caliper adapter/mount....or have any ideas on a design? I'm sort of thinking a similar bracket to Michael Ghia's (I hope I spelled that right) but I may have to put a notch in it to realign it with the rotor.

-And speaking of rotors....which one would I use for the front? Would an 86' turbo rotor bolt to the early setup or will I have to use the N/A rotor and center the caliper (I believe that the N/A ones are thinner and smaller than the Turbo rotors).