Hello,
Well, I've done my best, hope it helps.
Conversion VW Beetle brakediscs to Porsche 944 brakediscs Part 1
Big picture: Porsche 944 hub
Double striped/shaded (don't know the correct term)parts will have to be machined
Photo 1:
Left: Porsche 944 hub after being machined.
Right: Original 944 Porsche hub before machining.
Small picture:
Conversion-sleeve to use the original VW bearing.
Photo 2:
Make two cut-outs into the narrow part of the sleeve before pressing the sleeve into the hub. This will enable you to remove the bearing whenever needed.
Cheers,
Richard
Last edited by Richie; March 31st 2005 at 09:05.
|