Ok, still in the research phase of my engine build for my 1303 (daily driving, Auto-X racing). I only have a $1500 budget to work from for parts (long block, exaust and carbs).
This is what i have came up with so far...
-94mm P/C
-69mm C/W crank (is cast going to be fine for under 5000 rpm?)
-Eagle w-120 cam (or like it from Scat)
-40mm/35.5mm heads from CIP-1 (s.s. valves)
-Weber 40mm IDA dual carbs (or would 44mm be better?)
-Exaust is still up in the air, what should i look for?
I was thinking about geting the Scat Engine kit that includes, P/C, C/W crank, cam (20, 25, 30, 35 scat grind option), HD oil pump, lifters, bearings, gasket kit, coneting rods. and then geting the other little things i need like push rods and tubes, full flow parts, intake and exaust... the Scat kit i have seen for $520 bucks online.
I calculated it out and it came to be around 1,300-1,400 bucks with including carbs.
Any ways, what should i get for push rods, full flow parts. What kind of comp should i run (how can i get a desired comp any ways?)?
This is my first engine build, i need all the help i can get!
Thanks!
Jonathan