View Single Post
  #1333  
Old November 5th 2013, 03:53
Wally's Avatar
Wally Wally is offline
Registered User
 
Join Date: Nov 2002
Location: The Netherlands
Posts: 2,552
Quote:
Originally Posted by Clatter View Post
Can that case still be good after being subject to the past abuse?
Spread center main?
Pounded out/line bore needed?

Dying to see how the case looks.
That last crank was a stock 1.7, right?
Just balanced, no counterweights, IIRC.

If you can just use the case as it sits, it would speak very highly of the setup....
This is another case. I sold the former 2,2 engine as a N/A set-up, but if you go back some pages you'll read that I have openend the engine to change a few things (cam, rods) and that the case was even inspected for hairline cracks and all was good to go again. Even bearings were still good and could have been used again. I replaced them anyways though back then.

The crank was indeed stock 1,7 re-hardenend, polished and balanced. Nothing more.

This time it will be 8mm more stroke, chro-mo forged & counterweighted




Last edited by Wally; December 22nd 2017 at 05:55.
Reply With Quote