View Single Post
  #41  
Old April 1st 2006, 20:56
Mikey's Avatar
Mikey Mikey is offline
Registered User
 
Join Date: Aug 2004
Location: Owensboro, Kentucky, USA
Posts: 637
After a little work, and a little help from a 'Cherry Picker'. I managed to get my body back on my pan, by myself. I rolled it up in the garage and put it up on four jackstands, bolted the lines up and nervously checked the fit...

PERFECT! well, not 100% but concidering I made the water lines fit the pan and not the pan and the body. The're great. I thought they'd work out, but I have to admit, I did have my doubts. The passenger side is like I hoped, pretty much a straight shot. But the Driver's side is another story. I think I might up having to use a bleeder similar to Volkdent's.

In the last two pictures, I have a little clearance issue. Then again, it could be a lot worse. It could have hit the body.

Comments are always welcome.
Thanks...
Attached Images
File Type: jpg Coolant Line Install 022 (Small).jpg (42.0 KB, 91 views)
File Type: jpg Coolant Line Install 023 (Small).jpg (42.1 KB, 87 views)
File Type: jpg Coolant Line Install 024 (Small).jpg (46.0 KB, 77 views)
File Type: jpg Coolant Line Install 025 (Small).jpg (44.2 KB, 87 views)
File Type: jpg Coolant Line Install 026 (Small).jpg (46.6 KB, 96 views)
__________________
Mike
'04 R32 Tornado Red
'02 New Beetle TDI - Daily driver
'64 Ghia - Project!!-Subaru EJ20T, MS/EDIS, 993 brakes, 914 Tranny...
Reply With Quote