NJV,
Thanks for the reply..
This is going on the same pan.. The reason I am doing an off pan is so that I can redo the floor pans, kersher reinforcement bar, 901 tranny and type IV conversion.. Also POR-15.. Looking at the engine and tranny, but unfortunately have to go away on business for two weeks.. But that's another story..
Figured it would be easier to install and test fit the above, and do it right once and for all..
Do you have some pics of where exactly to weld some 1" square tubing to the A and B pillar things..
Sorry for my ignorance I just don't want to damage a good body.. The body doesn't look like it has a lot of rust.. but then again I haven't had the paint removed yet..
If anyone has pics please let me know or send to
olaverriam@yahoo.com
Sincerely
Alex