View Single Post
  #73  
Old October 2nd 2015, 10:52
effvee effvee is offline
Registered User
 
Join Date: Aug 2002
Location: California
Posts: 701
Good morning, was the torsion bar/housing cut away? Was your engine/trans raised any. Will you be using a lessor poundage torsion bar, along with coil overs?. I think your model of G-50 may be longer than Walter's, from the look of your tailshaft housing. Have you seen Walter's picture of comparison and measurement of his 915 verses the G50. How much more in length will your engine be rearward than its original location.The reason for my questions are,I am toying with the idea of a subaru EZ30. By it being a 6 cylinder, rear apron clearances I need to be mindful of.

Very nice work.
Reply With Quote